6513    MSDS for WearMax Formula One Shield

Trustor Coatings, 401 North 72 nd Ave., Wausau, WI 54401
24 Hour Emergency Telephone: (715) 849-8080

Section 1. PRODUCT IDENTIFICATION




PRODUCT NAME: 6513 FORMULA ONE SHIELD (WATER BORN SYSTEM)
CHEMICAL FAMILY: MIXTURE OF PU AND ACRYLIC DISPERSIONS (KEEP FROM FREEZING)

Section 2. HAZARDOUS INGREDIENTS AND EXPOSURE LIMITS
Substances presenting a health hazard within the meaning of the Dangerous Substances Directive 67/548/EEC

CAS
Chemical Name Number Conc. Phrases
2-butoxyethanol 111-76-2 0.043 lb./Gal 20/21/22-37
N-Methylpyrollidone 872-50-4 0.258 lb./Gal. 36/38 S 41
1,2 – propanediol 000057-55-6 0.086 lb./Gal. None
Tripropylen Glycol
Methyl Ether 25498-49-1 0.516 lb./Gal. None
(See full text of R phrases under chapter 16)

Section 3. HAZARDS IDENTIFICATION
The Product is not classified as dangerous according to the CHIP Regulations. (also refer to Section 11.)

Section 4. FIRST AID MEASURES
General: In all cases of doubt, or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious person.
Inhalation: Remove to fresh air, keep patient warm and at rest. If breathing is irregular or stopped, administer artificial respiration. Give nothing by mouth. If unconscious place in recovery position and seek medical advice.
Eye Contact: Contact lenses should be removed.
Irrigate copiously with clean fresh water for at least 10 minutes, holding the eyelids apart and then seek medical advice.
Skin Contact: Remove contaminated clothing. Wash skin thoroughly with soap and water or use recognized skin cleanser. DO NOT use solvents or thinners.
Ingestion: If accidentally swallowed obtain immediate medical attention. Keep at rest. Do NOT induce vomiting.

Section 5. FIRE – FIGHTING MEASURES
Extinguishing media:
Recommended: alcohol resistant foam, CO2, powders, water spray.
Not to be used: Water jet.
Recommendations: Due to the organic solvents content of the preparation, fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Appropriate breathing apparatus may be required. Cool closed containers exposed to fire with water. Do not allow run off from fire fighting to enter drains or watercourses.

Section 6. ACCIDENTAL RELEASE MEASURES

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
Avoid breathing vapors.
Exclude sources of ignition and ventilate the area. Refer to protective measures listed in sections 7 and 8. Contain and collect spillage with non-combustible absorbent materials like sand, diatomaceous earth, vermiculite, or earth. Place in container for disposal according to local regulations. Clean up with detergent but do not use solvents. Do not allow to enter drains or watercourses. If material enters drains or sewers, call local sewer or state authority.

Section 7. HANDLING AND STORAGE

HANDLING:
Keep Container tightly closed. Exclude sources of heat, sparks and open flames. Avoid skin and eye contact as well as inhalation of vapor (and spray mist.) Smoking eating and drinking should be prohibited in areas of storage and use.
For personal protection , see Section8.
Never use to empty, the container is not a pressure vessel. Always keep in containers made from the same material as the supply container. The manual Handling Operations Regulations may apply to the handling of containers of this product. Refer to the guide weight indicated on the container when carrying out of assessments.
STORAGE:
Observe the label precautions. Store between 10 and 30 degree C in a dry and well ventilated place away from sources of heat, ignition and direct sunlight. Prevent unauthorized access. Containers which are opened should be properly resealed and kept upright to prevent leakage. Store separately from oxidising agents and strongly alkaline and strongly acidic materials.

Section 8. EXPOSURE CONTROL/PERSONAL PROTECTION

PERSONAL PROTECTIVE EQUIPMENT:
Respiratory Protection: When works are facing concentrations above the exposure limit they must use appropriate certified respirators.
Hand Protection: For prolonged or repeated contact, use nitrile, neoprene or latex rubber gloves. Barrier creams may help to protect the exposed areas of the skin, they should now ever not apply once exposure has occurred.
Eye Protection: Use safety eyewear designed to protect against splash of liquids.
Skin Protection: All parts of the body should be washed after contact.
Exposure Limits: Occupational exposure limit for:
CAS – No. Names STEL LTEL
111– 76 – 2 2-butoxyethanol 25.000 p
Engineering Measures: Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. If these are not sufficient to maintain concentrations of particulate and solvent vapors below the OEL suitable respiratory protection must be worn.

Section 9. PHYSICAL AND CHEMICAL PROPERTIES
Physical state viscous Method
Flash point >210°F
Viscosity at 20?C 16 s 4 mm DIN 53211
Specific gravity 1.02
Flammable limits Lower: No Data available
Upper: No Data available
Solubility in water miscible
pH value 7.8 – 8.6

Section 10. STABILITY AND REACTIVITY

CHEMICAL STABILITY: Stable under recommended storage and handling conditions. (See section 7) When exposed to high temperatures, may produce hazardous decomposition products such as carbon monoxide, smoke, oxides of nitrogen. Keep away from oxidizing agents, strong alkaline and strongly acid materials in order to avoid exothermic reactions.

Section 11. TOXICOLOGICAL INFORMATION

There are no data available on the preparation itself. Repeated or prolonged contact with the skin may cause removal of natural fat from the skin resulting in non-allergic dermatitis and absorption through the skin.
Liquid splashed in the eyes may cause irritation and reversible damage.

Section 12. ECOLOGICAL INFORMATION

There are no data available on the preparation itself. The product should not be allowed to enter drains or watercourses or be deposited where it can affect ground or surface waters. The Air Pollution Control requirements of regulations made under Environment Protection Act may apply to the use of this product.

Section 13. DISPOSAL CONSIDERATIONS

Dispose of material in accordance with federal, state and local regulations.

Section 14. TRANSPORT INFORMATION

The Product is not classified as dangerous for carriage.

Section 15. REGULATORY INFORMATION
The requirements of the Classification Packaging and Labeling of Dangerous Substances Regulations.
Danger classification:

Contains:
R phrases: 20/21/22-37-36/38
S phrases: 41
Other phrases:

Section 16. other information

Full text of R phrases appearing in section 2:
20/21/22 Harmful by inhalation, in contact with skin and if swallowed.
37-36/38 Irritating to respiratory system, skin and eyes.

HMIS Hazard ratings:
Health 1
Flammability 0
Reactivity 0
Personal Protection: see section 8

The information of this MSDS is based on the present state of our knowledge and on current EEC and national laws as the user’s working conditions are beyond our knowledge and control. The product is not to be used for other purposes than those specified under section 1 without first obtaining written handling instructions. It is always the responsibility of the user to take all necessary steps in order to fulfill the demand laid down in the local rules and legislation. The information in this MSDS is meant as a description of the safety requirements of our product; it is not to be considered as a guarantee of the properties of the product.

Trustor Coatings believes the statements, technical information and recommendations contained herein are reliable. They are given without warranty or guarantee of any kind, expressed or implied.

DATE ISSUED: November 29, 2000 PREPARED BY: Trustor Coatings