SOY•Gel™ is an industrial strength and
consumer friendly paint, varnish, and urethane remover made with
100% American grown soybeans. The low evaporation rate of SOY•Gel™ and its gel formulation make it possible to remove
several layers of paint in one application. During the removal
of lead based paint, lead becomes encapsulated in the gel,
preventing airborne lead particles, allowing for safe and easy
disposal. contains SOY•Gel™ no methylene chloride, is not an
alkaline based stripper and cleans up easily with water. Unlike
more traditional paint strippers
SOY•Gel™ lets you work without
the odor. Indoors or outdoors, you can be guaranteed a safe
restoration process with SOY•Gel™.
APPLICATION:
SOY•Gel™ is safe to use on wood, brick, stone, metal, plaster,
concrete, and many other surfaces. Do not use on plastic, PVC,
rubber or dry wall. SOY•Gel™ may be used indoors or outdoors.
When used outdoors, protect plant and vegetation with a plastic
drop cloth. SOY•Gel™ may be used on vertical as well as
horizontal projects.
Apply a thick, even layer of SOY Gel, generally between 1/16 and 1/8 inch to the coating to be removed by using pouring, brushing, or airless sprayer (piston pumped with tip of 519 or similar). If applying with brush, do not apply as you would paint. Don't brush or scrape the surface until the stripper has had time to work. Check the progress of the stripping action by using a scraper to see if the coating is softened down to the surface. If not, wait longer and recheck. SOY•Gel™ will remain wet and working for several hours. Longer is better. Let the stripper do the work. If SOY•Gel™ is left to sit outdoors, cover with a light plastic drop cloth to prolong the stripper's wet time. Once the coating is softened, remove it with a scraper, industrial wet vacuum, or other stripping tool. Reapply stripper, if necessary. Repeat steps above. After use, clean remaining thin residue with water, using a scrub brush and/or mop or power washer. Ensure to scrape or vacuum excess removed coating and SOY•Gel™ before using a power washer for final cleaning. Always use care to prevent over spray from getting on surfaces other than the one being prepped. Allow surface to dry before further preparations.
| • Flash Point: Above 200°F • pH Level: 6.80 pH of 1/10 wt/wt solution in soft water. • Vapor Pressure: Not determined • Odor: Mild Odor • Conditions to avoid: Strong oxidizing agents. • Health Hazards: May cause moderate eye irritation. May cause delayed skin irritation. May be harmful if swallowed in large amounts. • Packaged: Quart, Gallon, 2 1/2 Gallon, Five Gallon, 55 Gallon Drum • Coverage: Horizontal - Up to 200 sq. ft. per gallon Vertical - Up to 130 sq. ft. per gallon |
Common Uses • Lead-based paint removal • Latex paint removal • Enamel paint removal • Single and Two part epoxies (two part solid count must be lower than 40%) • Urethane removal • Varnish removal • Concrete sealer removal |
Revision Date 12/11/2006